30 Search Results

Herein, we examine the impact of Ga⁺ ion kinetic energy and the target material type on the extent of ion implantation and structural damage in atomic force microscopy probes made of Al₂O₃ and ZnO manufactured by focused ion beam (FIB) using scanning transmission electron microscopy and energy-dispersive X-ray mapping. Penetration of Ga into the Al₂O₃ lattice induced structural distortions and amorphization. For ZnO probes, Ga is uniformly dispersed across the surface, resulting in the formation of distinct clusters. Atom probe tomography further validates the Ga distributions in Al₂O₃ and ZnO nanoprobes. Complementary Monte Carlo simulations with the transport of ionsmore » in the matter program indicated that the introduction of Ga⁺ prompts the generation of cation and anion vacancies, an occurrence more pronounced in Al₂O₃ compared to ZnO. In conclusion, this study not only enriches the knowledge of ion-matter interactions, but also serves as a practical guide for the fabrication of nanoscale functionalized AFM probes.« less

Abstract Low‐loaded platinum‐group single‐atom catalysts on CeO ₂ (M ₁ /CeO ₂ ) were synthesized via high‐temperature atom trapping (AT) and tested for the NO+CO reaction under dry and wet conditions. The activity of these catalysts for NO+CO reaction follows the order Rh>Pd≈Ru>Pt>Ir. For Rh, Ru, and Pd single‐atom catalysts, the N ₂ O byproduct is formed but not clearly observed in Ir and Pt cases, which may result from the higher reaction temperature (>200 °C) required for Pt and Ir catalysts. The presence of water can promote the activity of these M ₁ /CeO ₂ catalysts for the NO+CO reaction.more » Under wet conditions, significant NH ₃ formation occurred during the reaction, which is due to the co‐existence of water‐gas‐shift reaction on these catalysts. Compared with Pt, Pd and Ir, the Rh and Ru single‐atom catalysts show higher selectivity to NH ₃ species, resulting from the hydride species on the surface. Among all tested catalysts, Ru ₁ /CeO ₂ shows the highest production of ammonia and highest CO conversion due to excellent water‐gas‐shift activity, whereas Pd ₁ /CeO ₂ shows lowest ammonia production. Rh ₁ /CeO ₂ shows the best low temperature NO reduction activity among all tested catalysts.« less

Here, in this study, we examined the effect of gamma radiation on the stabilities of aluminum hydroxide (gibbsite) and aluminum oxyhydroxide (boehmite) nanoparticles in relation to their thermal decomposition. X-ray diffraction (XRD) patterns and scanning electron microscopy (SEM) images revealed no significant differences in mineral components or morphology before and after radiation. However, thermogravimetric and differential scanning calorimetry (TGA/DSC) analyses showed that both boehmite and gibbsite nanoparticles experienced decreased mass loss following irradiation. Raman and attenuated total reflection-Fourier transfer infrared (ATR-FTIR) spectra indicated that a fraction of the hydroxyl content in both cases was selectively cleaved by radiation, primarily atmore » the particle surfaces. Quantitative analyses of thermal mass loss behavior demonstrated that irradiated boehmite and gibbsite nanoparticles had higher activation energies than their pristine counterparts, with the extent of the increase dependent on the total dose. Taken together, these findings suggest that exposure to a sufficient dose of ionizing radiation alters these materials such that they are less prone to decomposition by dehydration. This increased stability may be due to the decreased hydrous nature of the samples after radiation exposure, which was supported by further high temperature drop calorimetry. Additionally, a radiation-induced amorphous phase on the nanoparticle surfaces appears to have a permanent and positive influence on their thermodynamic stabilities.« less

Understanding the dissolution of boehmite in highly alkaline solutions is important to the processing of the complex nuclear wastes stored at the Hanford (WA) and Savannah River (SC) sites. Here, we report the adsorption of model carboxylate anions on boehmite nanoplates in alkaline solutions and their effects on subsequent boehmite dissolution in 3 M NaOH at 80 °C. Although expectedly lower than at circumneutral pH, adsorption of oxalate at pH 13 at room temperature was significant and remained so through a linear decrease to 3 M NaOH conditions with no evidence for the appearance of new phases. Modeling of themore » adsorption data and rate were consistent with the formation of outer-sphere surface complexes. By using these conditions to preload the boehmite nanoplates with oxalate, and separately acetate, we measured and compared their dissolution behavior at 80 °C and observed a clear suppression of the dissolution rate for the case of adsorbed oxalate by 23% and for adsorbed acetate by 10% compared to pure solids. Ex situ scanning electron microscopy (SEM) and transmission electron microscopy (TEM) characterization revealed no detectable difference in the morphologic evolution of the dissolving boehmite materials. In conclusion, we nonetheless conclude that pre-adsorbed carboxylate anions, even as nominally weakly bound outer-sphere complexes, can persist on the surface through highly alkaline conditions, decreasing the density of dissolution-active sites and thereby adding an extrinsic control on the dissolution rate.« less

Iron-based redox-active minerals are ubiquitous in soils, sediments, and aquatic systems. Their dissolution is of great importance for microbial impacts on carbon cycling and the biogeochemistry of the lithosphere and hydrosphere. Despite its widespread significance and extensive prior study, the atomic-to-nanoscale mechanisms of dissolution remain poorly understood, particularly the interplay between acidic and reductive processes. Here, we use in situ liquid-phase-transmission electron microscopy (LP-TEM) and simulations of radiolysis to probe and control acidic versus reductive dissolution of akaganeite (β–FeOOH) nanorods. Informed by crystal structure and surface chemistry, the balance between acidic dissolution at rod tips and reductive dissolution at rodmore » sides was systematically varied using pH buffers, background chloride anions, and electron beam dose. We find that buffers, such as bis-tris, effectively inhibited dissolution by consuming radiolytic acidic and reducing species such as superoxides and aqueous electrons. In contrast, chloride anions simultaneously suppressed dissolution at rod tips by stabilizing structural elements while promoting dissolution at rod sides through surface complexation. Dissolution behaviors were systematically varied by shifting the balance between acidic and reductive attacks. The findings show LP-TEM combined with simulations of radiolysis effects can provide a unique and versatile platform for quantitatively investigating dissolution mechanisms, with implications for understanding metal cycling in natural environments and the development of tailored nanomaterials.« less

We report that it is well known that phosphate retention in soils and sediments is strongly influenced by binding to secondary iron oxides, there have been relatively few studies examining its adsorption/desorption behavior on multicomponent particles of realistic natural complexity. In this study, natural Mn-rich limonite (LM), was used to prepare naturally complex Fe- and Mn-oxide composite materials to examine phosphate adsorption/desorption. To clarify the role of the Mn-oxides, results for the LM sample were compared to those for an acid treated version (LAT), in which the acid-extractable Mn-oxide fraction has been selectively eliminated while leaving the Fe-oxide fraction intact.more » The saturated adsorption capacity on LAT was almost double that on LM, suggesting that phosphate adsorption to the iron oxides is strongly occluded by the Mn-oxide fraction. This result is reinforced by the comparing the pH dependence and fits to adsorption isotherms, and by desorption experiments and STEM-EDS mapping showing that phosphate loading on Mn-oxides was limited. Hence, although the collective results confirm that phosphate uptake and strong binding is selectively controlled by the Fe-oxide fraction, our study reveals that the Mn-oxide fraction strongly interferes with this process. Therefore, phosphate uptake behavior on metal oxides cannot be predicted solely on the basis of the Fe-oxide fraction present, but instead must take into account the deleterious impacts of other intimately associated phases. For co-diagenetic Fe/Mn-oxide composites in particular, Mn-oxides appear to severely limit phosphate uptake on the Fe-oxide fraction, either by hindering access to binding sites on the Fe-oxide or by lowering their affinity for P.« less

Gradient structures containing nanograins in the surface layer have been introduced into Inconel 718 (IN718) nickel-based alloy using the surface mechanical grinding treatment technique. The thermal stability of the gradient IN718 alloy was investigated. Annealing studies reveal that nanograins with a grain size smaller than 40 nm exhibited significantly better thermal stability than those with larger grain size. Transmission electron microscopy analyses reveal that the enhanced thermal stability was attributed to the formation of grain boundaries with low energy configurations. This study provides new insight on strategies to improve the thermal stability of nanocrystalline metals.